Everyone knows that the design of the terminal is precise, and a slight touch will cause deformation. This type of deformation will cause difficulty in assembly at a small amount, and cause poor electrical performance. Next, I will introduce how professional terminal connection wire processing plants can protect terminal connection wires!
When the terminals are supplied with materials, most of them are part of the disk ring terminals are equipped with shaft. The chain-shaped terminals are protected by paper tape between them and protected by paper plate or plastic shaft on the outside.
During the production process, the terminal machine has a corresponding shaft to fix the terminal board! After the terminal connection wire is made, put it into the fixed cup, protected by rubber band, and then put it into the customized box. When packing, bubble bag will be added if the terminal is exposed.
The wire harness is composed of two parts: the connector and the wire. Here is an introduction to the structure and function of the terminal in the connector:
1. Contact end (contact part): the part of the pin in contact with the pin holder
2. Wire barrel: the part where the conductor is crimped;
3. Insulation tube: the part that fixes the wire harness insulation;
4. Bell-shaped inlet sleeve: protect the wire from breaking and surface abrasion;
5. Spear hook: the locking hook when inserted into the shell;
6. Cut-off piece: the remaining part after cutting the tape;
7. Zigzag protrusion: make sure the wires are in good contact with grooves in the drum.